91九色蝌蚪_丁香六月狠狠综合天香_亚洲永久精品国产大片_国产b站免费版视频_老色鬼在线播放精品视频_天天看片97涩_小黄人福利导航_久久99精品国产麻豆婷婷_国产91精品精华液一区二区三区_91九色麻豆_综合亚洲欧美精品日韩?v_天天日天天日天天日天天日天天日天天日 _蜜月国产免费福利片_久久99国产精品片久久99蜜桃_国产精品无码专区在线观看_免费在线1区2区3区

當前位置： 首頁 >> 產業發展 >> 正文

Shape-memory properties of polycaprolactone polyurethane

時間:2004-12-07
關鍵詞:Shape memory properties polycaprolactone polyurethane 來源：International Symposium on Biological Polyesters ,Auguest 22-27, 2004

 

X. Jing*, and X. Chen

 

State Key Lab of Polymer Physics and Chemistry, Changchun Institute of Applied Chemistry

Chinese Academy of Sciences, Changchun, Jilin, 130022, China

 

Poly(e-caprolactone) (PCL) is a well known polymer with melting temperature (Tm) around 60ºC. It is biodegradable, at least in the presence of certain microorganism. Starting from low molecular weight PCL, we prepared polycaprolactone polyurethanes (PCLU) and examined their shape-memory properties.

e-Caprolactone was polymerized into a polymer with two –OH end-groups, i.e., HO-PCL-OH. This was achieved by using stannous octoate (Sn(Oct)2) as catalyst and ethylene glycol as initiator. Their molecular weight was adjusted over the range of 500~10,000.

These polyester precursors were reacted with dicyanates in the presence of ethylene glycol in toluene solution at 65ºC and catalyzed by Sn(Oct)2 to get corresponding PCLU.

The shape-memory effects were observed for tensile deformation, compressive deformation and other complicated deformations (See Fig. 1 for an example). The recovery percentage was 94-100% for tensile elongation or compression of 300%. The recoverable deformation xould be obtained at a temperature was in the range of 30-60ºC. The lowest shape-recovery temperature (LRT) determined by thermal mechanical analysis (TMA) was much lower than Tm of PCLU. By changing Mw of PCL and hard/soft ratio, the LRT could be adjusted to body-temperature, e.g., 37-42ºC. It meant potential medical usage of PCLU as shape-memory devices.


To examine the driving force for shape memory, the contracting force in tensile specimen or the expanding force in compressed specimen was measured as temperature arose. The results showed that strong inner stress existing in the specimens due to the post-deformation and fixation was the driving force for shape recovery and pre-melting occurring in deformed specimens.  

 

                              

              (a)                                 (b)                                  (c)

Fig. 1 A real shape-memory circle. (a) Original cylinder shape; (b) Flower shape at 20ºC; (c) recovered shape at 40ºC.

 

論文來源：International Symposium on Biological Polyesters ,Auguest 22-27, 2004